![]() ![]() The support generator itself works on a grid internally, so the supported/unsupported areas are not infinitely detailed. IMPORTANT NOTE: Your selection will not be completely obeyed when the painted region is very small. You can block some automatically generated supports with blockers while at the same time mark areas which did not get automatic supports with enforcers. In this case, set supports to Everywhere or From build plate only. With very complex models, it's possible you might want to use both enforcers and blockers at the same time. Enforcing and blocking supports at the same time Supports will now be generated based on the set Overhang threshold except for the area blocked by the painted Support blockers. These modes also turn on Auto-generated supportsin Print settings - Support material. If you're using support blockers, you should change supports to Everywhere or From build plate only. This second use-case is useful if you set the Overhang threshold very low, so only very steep overhangs will get auto-generated supports. Of course, you can also set supports to Everywhere or From build plate only and use support enforcers to mark additional areas that need to be supported. If you're painting support enforcers, it makes the most sense to change supports to For support enforcers only. By default, support generation is set to None in the right panel. Do not forget to enable supports if you want to actually generate them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |